Henry Mt Rpt.

Located in Garfield County, Utah this mountain range is very remote. Surrounded by desert this isolated range of mountains is home to one of the largest free-roaming herds of Bison in the U.S. GPS coordinates for this repeater are:
N 38° 04′ 21.10″
W 110° 47′ 41.34″
11418 ft Elevation

Henry Mt Rept coverage Map
Mt. Ellen (Henry Mtn) Repeater

This repeater site is located in Garfield County, Utah on Mt. Ellen. This repeater consists of a VHF repeater with a UHF link repeater. Due to the remoteness of this site the repeater is on a timer to turn off the VHF transmitter and the UHF link repeater to slow down the power drain at this site. This means that this repeater will not hear what the system is transmitting unless the Mt. Ellen repeater is first keyed.

This repeater site is our most remote sites. Power is supplied by solar power with a bank of batteries only. At over 11,000 feet trips to this site are few do to the lateness of snow melt.

The antenna is located at the top of the now shortened tower which became shortened when the top half of the tower failed and tipped over most likely due to ice loading.

This repeater covers areas around the Henry Mountain range is Southeastern Utah including Capitol Reef National Park, Hanksville, Hite, Boulder, Escalante, and Bullfrog.

Repeater Access Information
Repeater Callsign: 	K7SDC
Output Frequency:  	147.080 MHz
Input Frequency:   	147.680 MHz
Offset:		+600 kHz
Status:		Open
CTCSS (Tone SQ):	136.5 Hz
Mt. Ellen Coverage Map
Coverage Map

Pictures from Mt. Ellen

Road to the Repeater Site Repeater Building Mt. Ellen Repeater Antenna
Road to the Repeater Site Repeater Building Repeater Antenna
Mt. Ellen Radio Tower Intact Mt. Ellen Tower Failure KC7GHT's jeep on Mt. Ellen
Tower Intact Tower Failure Joe’s Jeep